• Call Support +86-17328959173

Maintenance and repair of bar chairs

The biggest advantage of the solid wood bar chair is the natural wood grain and the varied natural colors. Because solid wood is an organism that is constantly breathing, it is recommended to place it in an environment with a suitable temperature and humidity. At the same time, avoid placing beverages, chemicals or overheated objects on the surface to avoid damaging the natural color of the wooden surface. If it is made of melamine board, when there is a lot of dirt, it is recommended to use diluted neutral detergent with warm water to wipe it once, and then wipe it with water. Remember to wipe off the remaining water stains with a soft dry cloth and wait for it to be completely cleaned. Later, using maintenance wax to polish, even if you are done, only by paying attention to daily cleaning and maintenance can you make wooden furniture lasting.

After the cloth bar chair is purchased, first spray it with a fabric protectant for protection. The cloth bar chair can be patted with a dry towel during normal maintenance. Vacuum it at least once a week. Pay particular attention to removing the dust between the structures. When the surface of the cloth is stained, you can use a clean cloth dampened with water to wipe from the outside to the inside or use a fabric cleaner according to the instructions. Avoid wearing sweat, water and mud on the sofa. It is recommended that most of the fabric bar chairslinings and cushions are divided into hand washing and machine washing. You should check with the furniture dealer, because some of them may have special washing requirements. If a loose thread is found, do not tear it off by hand, and trim it neatly with scissors. All cloth covers should be washed dry-cleaned, not water-washed, and never bleached.
Bar chairs with plated bases should not be placed in a damp place, and should not be wiped with a damp cloth, especially soapy water or washing powder. The base part should avoid contact with substances such as hydrochloric acid, common salt, brine, etc., and should not be placed in the coal smoked roasting place. The rust on the plating base part can be applied to the rust with a brush or cotton yarn dipped in engine oil. After about 10 minutes, wipe it back and forth several times to remove the rust.

Post time: 2019-12-09